Lead details that fit and drain properly
Made for the junction
We form lead around the actual chimney, valley or abutment on your roof.
Movement allowed for
We detail the lead with roof shape, exposure and material movement in mind.
Coverings integrated
We connect leadwork carefully with nearby slate, tile and masonry.
Shape the lead around the roof, not vice versa
Lead protects the places where roofs change direction or meet another surface. Standard pieces rarely account for every chimney, valley, abutment or apron, so we form details to suit the roof in front of us. We assess the shape, substrate, exposure and adjoining covering before setting out the work. Accurate dressing and secure joints guide rain away from vulnerable transitions while allowing for suitable movement. This matters on both older roofs and new installations, where a small weakness in a junction can undo otherwise sound covering work.
Replace split or poorly formed lead cleanly
Lifted edges, splits and short overlaps can let water reach the material beneath. We remove defective sections where required and prepare the junction for replacement leadwork. The new detail is integrated with surrounding slate, tile or masonry rather than simply laid over the fault. Valleys need a clear route for concentrated rain, while chimney flashing and wall abutments must shed water onto the covering below. A neat finish improves the roof's appearance, but its first job is to keep those transitions dry.
Frequently asked questions
Why has the lead flashing split or lifted?
Lead can fail where movement has been restricted, fixings are poor or sections are formed at unsuitable lengths. Exposure and weak joints can add to the problem. We inspect the detail before deciding what needs replacement.
Can damaged leadwork be patched?
A local repair may be possible for a limited defect, but a patch is not sensible if the surrounding lead is split, badly formed or lifting. We assess the complete junction and recommend work that addresses its condition.
Does new leadwork need to match the surrounding roof?
It needs to integrate correctly with the surrounding slate, tile or masonry first. We also form and dress visible sections neatly, so the finished detail sits cleanly within the character of the roof.